Vanner 20-1050CUL-DC LifeStar Inverter Charger

Description

Inverter 20-1050CUL-DC
Output at 120 VAC RMS (Continuous Power Rating) 1050 Watts
Surge Capacity at 120 VAC (3 sec) 2100 Watts
Input Voltage, VDC (Deep Cycle Battery Recommended) 12 VDC, Nominal 10.5 VDC min, 16.0 VDC max.
AC Output Voltage 120 VAC +/- 5%
DC Current Draw (Battery)
OFF 0.017 Amps Typical
In Load Demand 0.09 Amps Typical
Full ON at No AC Load 0.7 Amps Typical
Full On with Load Approx. AC Load Watts +/- 10
Frequency 60 Hz +/- 0.2%
Output Wave Form Modified Sine Wave
Battery Charger
Charging Capacity (note “DC Source” section below) 55 Amps (High) 15 Amps (Low)
Input Voltage 120 VAC +/- 10%
Input Current 12.0 Amps
Bulk Voltage 14.2 VDC (flooded), 14.1 VDC (gel)
Float Voltage 13.2 VDC (flooded), 13.6 VDC (gel)
Bypass Transfer
Output Current, GFCI Outlet 12 Amps
DC Source
Output Voltage Battery Voltage
Output Current 20.0 Amps Max. (Current must be subtracted from “Charging Capacity” above)
Other Specifications
AC Input Termination** 3ft. Line Cord
AC Output Termination Duplex GFCI Receptacle
Ambient Temperature -20 degrees to +110 degreed F, -29 degrees to +43.4 degrees C
Cooling Air Fan Cooled
Chassis Aluminum
Dimensions 11.57”W x 5.94”H x 11.04”D
Weight 22 LBS
The 20-1050CUL-DC is a 12 VDC to 120 VAC inverter with a built-in battery charger/conditioner, transfer relay and KKK Spec 12V Portable Equipment Charging Circuit
This unit is equipped with an AC line cord for connecting AC input power (shore/utility power) and a receptacle with a Ground Fault Circuit Interrupter (GFCI) for AC output, this enables you to plug AC loads directly into the inverter
The DC cables have quick connectors to facilitate installation and pre-wiring of emergency vehicles
The 12V Portable Equipment Charging Circuit has a spring clamp for ease of installation
The transfer relay is powered by +12Vdc, the unit must be connected to the DC source for the transfer relay to work